Workshop

Ok, not quite the workshop.  I'm too embarrassed to photograph my workshop at the moment because it is such a mess.  Maybe I'll do a before/after animated gif shot.

This is my lathe that sits in the corner.  At the bottom of the picture in the foreground is the hand wheel of the Mill/Drill.  This is the before shot of the lathe.  Currently the lathe splash guard has been remove and is being extended.  You can see the between the lathe and the table.  I want to fill this gap to keep swarf off the floor.

Also stuck in the spindle at the moment is my spindle arbor.  I'm building an MT3 arbor with the same fitting as the lathe head stock so I can put it in the rotary table and mount the chucks on it.